Reversed Battery Cables

Don,

Are you talking about the toilet flush valve? Is so see this:

Thetford toilet flush valve leaking.
Toilet flush valve on 2012 r-pod 177 Thetford rv toilet failed and started to leak.

Replaced valve without removing the toilet.

Kneel down in front of toilet and when you look down back of the toilet you see the flush valve.

1 disconnect supply hose from the bottom of the valve.

2 remove on the right side of the valve body a brass phillips screw, connects valve to rear of the toilet, use stubby phillips screw driver to remove.

3 valve locks on the left side in a small groove and held by plastic pin, pull valve body out.

4 disconnect metal wire connected to flush handle, pull wire up from handle.

New valve

1 connect metal flush handle wire.

2 lock left side of valve in to groove and pin location.

3 screw brass screw back into rear of the toilet.

4 install new rubber gasket inside supply hose connector.

5 connect supply hose to bottom of valve and tighten

6 turn on pump, check for leaks.

THANKS Furpod, tracking.

Don, check those 40A fuses too.

Thanks.

Some info:

Radio will not turn ON
· Try the reset button.
· Check fuse.
· Check 12V+ on battery wire to radio (YELLOW wire).
· Check 12V+ on accessory wire to radio (RED wire).
· Check Ground.

Jensen Response:
If you have verified that there is proper 12 volt power going directly to the AWM968, please try a factory reset on the radio. You can do this bypressing and holding the AUDIO button to access the System Menu. The"BEEP" setting will display. Quick press the AUDIO button to accessthe "RESET" option. Press the VOL/PUSH/ENTER control to rest theE2PROM to factory default setting.