Scary event |
Post Reply | Page 12> |
Author | |
furpod
Moderator Group - pHp Joined: 25 Jul 2011 Location: Central KY Online Status: Offline Posts: 6128 |
Topic: Scary event Posted: 21 Nov 2013 at 10:02am |
I had a load of firewood pop up like that once. After reattaching I lifted the rear wheel almost off the ground testing. Had to have been my fault.
Now, when I hook up, I physically reach under with my finger and make sure the little part that holds the ball from below, is in fact, below the ball. it should be loose until you put the locking lever down, then it should pull up snug against the bottom of the ball. |
|
Bill-GA
Senior Member Joined: 13 Jan 2012 Location: Cumming, GA Online Status: Offline Posts: 214 |
Posted: 21 Nov 2013 at 9:12am |
Always look for the most simplistic solution to a problem - Occam'sRazor
|
|
Bill & Bev
13 yr old dachshund 'Elsa' 2010 RP-176T (tent & slide-out) 2011 Toyota Tundra 2WD TV |
|
Bill-GA
Senior Member Joined: 13 Jan 2012 Location: Cumming, GA Online Status: Offline Posts: 214 |
Posted: 20 Nov 2013 at 11:35pm |
I have learned that when the top of the hitch is seated on the ball properly and the locking lever is locked, the distance from the bottom of the hitch to the base where the ball is mounted is approx. the "width of my index finger". This is a quick check I ALWAYS do after the lever is locked.
Works for me.
|
|
Bill & Bev
13 yr old dachshund 'Elsa' 2010 RP-176T (tent & slide-out) 2011 Toyota Tundra 2WD TV |
|
ron_whitt
Senior Member Joined: 08 Sep 2011 Location: Chesterville On Online Status: Offline Posts: 261 |
Posted: 20 Nov 2013 at 10:39pm |
The same thing happened to us also, we thought the trailer was down on the ball. At the time I thought the locking lever closed to "easily" . Now I look for some resistance when pushing the lever down to insert the pin through the hole. But I will now also after closing lever and inserting pin, try to crank up the TV to see if the tongue slides off the ball. That is a good way to tell if you are really locked onto the hitch. We were very lucky there was no damage at all to anything. Thanks fellow podders.
|
|
Ron & Shirley
2020 Tacoma 2012 177 rpod |
|
Sleepless
Senior Member Joined: 07 Jun 2013 Location: Titusville, FL Online Status: Offline Posts: 556 |
Posted: 20 Nov 2013 at 10:11pm |
That is one of the side benefits of using a standard WDH. You have to raise the tongue and the hitch considerably higher than normal to properly attach the bars.
|
|
2014 R-Pod 178 (OUR POD)
2009 Chevrolet Avalanche |
|
techntrek
Admin Group - pHp Joined: 29 Jul 2009 Location: MD Online Status: Offline Posts: 9059 |
Posted: 20 Nov 2013 at 7:45pm |
It sounds like it was in fact latched with the pin in place. What happens is it appears the ball is all the way in the socket but instead it is sitting on the bottom of the latch. Visually there is little difference. As mentioned already, lifting the rear of the TV higher than its non-towing position confirms it is properly latched. Remember it sags when the pod is attached so just lifting it back to where it started doesn't prove anything.
|
|
Doug ~ '10 171 (2009-2015) ~ 2008 Salem ~ Pod instruction manual
|
|
Thinker
Senior Member Joined: 25 Feb 2013 Location: S. Mississippi Online Status: Offline Posts: 171 |
Posted: 20 Nov 2013 at 4:28pm |
Totally agree... cannot happen when all is done correctly. As stated, look first at the ball size. To the untrained eye it is difficult to tell the difference in 1 7/8 vs 2 inch balls unless they are side by side. There should be markings on the ball. If the ball is correct, then the hitch was not latched and locked. Put the latch down until it clicks Insert locking pin horizontally through the latch. After the "bump" with the trailer bouncing off, the latch could have fallen into the down position thus giving the false impression that it had been down during the event. |
|
Tow Vehicle: 2013 Pathfinder 4WD R-POD Model 171
|
|
techntrek
Admin Group - pHp Joined: 29 Jul 2009 Location: MD Online Status: Offline Posts: 9059 |
Posted: 20 Nov 2013 at 2:55pm |
+1 to all the above.
|
|
Doug ~ '10 171 (2009-2015) ~ 2008 Salem ~ Pod instruction manual
|
|
David and Danette
podders Helping podders - pHp Joined: 24 Nov 2009 Online Status: Offline Posts: 1218 |
Posted: 20 Nov 2013 at 2:52pm |
I would not be nervous, I agree with the above posts you most likely did not have it hitched properly or you could have a 17/8 ball. I to have never known this to happen where it was not human error. The good thing is that no harm was done and you now know to make sure the hitch is secured properly before traveling. Happy camping! David
|
|
2018 Vista Cruiser 19BFD (2018-
2012 Vibe 6503 (2014-2019) 2009 r-pod 171 (2009-2014) Middle Tn 2014 Ram 1500 Quad cab |
|
kymooses
Senior Member Joined: 01 Aug 2010 Location: Louisville, Ky Online Status: Offline Posts: 1807 |
Posted: 20 Nov 2013 at 12:31pm |
Yup this is one of the best ways to make sure you are actually locked. Set it and then jack back up until you see your TV raise slightly. Only then can you 100% be sure it's locked securely. This is not the first time owners have had this happening, lots of stories like this over the years here.
|
|
Post Reply | Page 12> |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |