We recently purchased a 2014 177 and have already enjoyed it very much. I purchased a Yamaha 2400iSHC since prior reviews indicated that it could definitely run the 13.5k BTU air conditioner, which it did well. What I found, though, is that after 4-5 hours of running the AC with the compressor on about 1/3 of the time, the generator was almost out of fuel. Since I didn't want to refuel the generator in the middle of the night, I wanted to add an external fuel tank. This is not quite as easy as with Honda models as those have an onboard fuel pump. Yamahas are gravity fed, so you either must get an external fuel pump or use a gravity fed system. I opted for the latter as it is easier and cheaper.
Following the description of a very similar mod done by Budward (many thanks
![](smileys/smiley20.gif)
), I have completed the mod that will allow it to be easily fueled by any external fuel tank or gas can.
Here is what the generator looks like when the panel on the right side is removed, which involves loosening two screws at the top and carefully popping open the left and right sides. In this shot, you can see that I've cut the stock fuel line and added in a brass T connection with screw clamps with the 3/8" fuel line meets up with the stock fuel line.
Here, I've added the fuel line that will eventually go to my external fuel tank. I pushed it through one of the cooling ports on the side panel. This never gets very hot, so it's fine.
And here is what the external assembly looks like. The fuel primer bulb installs very easily; just cut the fuel line and attach the ends to the primer while making sure that you get the direction right. Here in the middle is what took a little work to get right.
I wanted to be able to easily disconnect the external fuel line from the external fuel tank without fuel running out of either the generator or the external fuel tank. So this is what I came up with. I put both female and male quick connect adaptors on either end of the fuel line and then joined the male adaptors with the brass coupler in the middle.
So what does this last assembly allow me to do? A lot!
(1) If I want to run the generator with the stock fuel tank, I disconnect both of the female adaptors (on both the left and right side as seen in the last picture) and flip the fuel switch on the front of the generator to 'ON'.
(2) If I want to run the generator with an external fuel tank, I flip the fuel switch to 'OFF' (this prevents fuel from back-flowing into the stock fuel tank), connect the two adaptors together, and squeeze the priming bulb to prime the fuel line. Obviously, the external fuel tank must be higher than the generator for this to work.
(3) If I want to drain the stock fuel tank at the end of the season, I disconnect the fuel line on the left, going to the external fuel tank, but leave on the right side, going to the stock fuel tank. Now I can drain the stock fuel tank quickly and easily.
The total cost of the mod was about $75, half of which was for the primer bulb. It was a bit pricey, but I wanted a really good one that I could depend on. I could've gotten one for about $12, but it wouldn't have been nearly as solidly built. I bought everything at my local NAPA auto parts store, and the mod took about 20 minutes to do.
If I were to do it again, the only thing I would do differently is get a longer bit of fuel line. I did this with 6', but 8-9' would have been even better. At $2 per foot, it's not very expensive.