Mounted backup light to stabilizer and spare tire bracket under rear of the r-pod 177.
Used zipties to connect receiver unit to cross member behind fresh water storage tank.
Connected the wires to rear fender marker light (slide out side) wires located underneath the r-pod. close to the drain lines.
Open the existing plastic conduit and pull the fender light wire out.
One wire is white with green stripe = positive and the other is white that = ground.
Quick tap wire connectors to connect backup light wires to fender light wires.
Materials.
Roll of flex plastic 3/8 conduit to protect new installed wires.
Inline fuse holder for 5 amp fuse weather tight.
5 feet of red wire and 5 feet of white wire to make up the distance and butt connectors.
Connected red and yellow lead from sending unit together = 12 volt, butt splice to wire going to the fender light wires, connect to white wire with green stripe with quick tap.
Connected other yellow to backup light, to power light
Connected the black wire from backup light and the black wire from receiver unit to ground wire butt spliced to wire going to fender light wires, connect to white wire with quick tap.
Remote turns backup light on and off standing 40 feet away from the r-pod.