Furpod, your video is priceless and without it, we would have given up on ever trying the rdome out so thank you very, very much.
Just to give you the final story:
We initially threaded the top on backwards - back to video view #2!!
We then successfully assembled the rdome with some struggles due to an unplanned burst of wind that is typical of Colorado so we did not continue with staking all around. We did have some difficulty getting the grey suction cups to stick; avoiding decals.
Upon threading the top of the rdome to the channel on the roof, we noticed the threading rod hung down about 6" on the opposite side but proceeded regardless.
After taking everything down, we measured and checked with the instruction flyer only to find out we were given the wrong rdome! They are closed this weekend, Labor Day, so we will call tomorrow, 9/6 and request the right size be sent to us and see what happens!
I thought this valuable information to share in case anyone out there may have had the same misfortune. I do look forward to using the 'extra' room but will not be able to until next year!
We are off to see the Aspen changing and camp off the grid at Weston Pass outside of Leadville, CO.
Thank You again for your valuable information sharing and if you ever make it to Colorado, we would love to put you up as I am quite sure RPoders are all trustworthy, upstanding people!!!