Author |
Share Topic Topic Search Topic Options
|
mylopez
Newbie
Joined: 23 Jun 2016
Location: CA - California
Online Status: Offline
Posts: 6
|
Topic: Double Steps for R-Pod 178 Posted: 16 Feb 2019 at 12:01pm |
What double steps can I buy to replace single step up to my 178
|
|
jato
Senior Member
Joined: 23 Feb 2012
Location: Kewadin, MI
Online Status: Offline
Posts: 3216
|
Posted: 16 Feb 2019 at 2:34pm |
After adding a 3.5" lift kit to our 177 I added a double step to make it easier to enter and exit. Last summer I purchased the Stromburg Carlson SMFP 2100 double step. Cost with shipping was just over a hundred dollars. Took me about 2.25 hours to take off the original and then install the new one. Front holes lined up but the rear ones had to be enlarged to make it so it could be bolted on correctly. Definitely use a floor jack or have someone with you to hold up the double step while installing to make the job easier.
|
God's pod
'11 model 177
'17 Ford F-150 4WD 3.5 Ecoboost
Jim and Diane by beautiful Torch Lake
"...and you will know the Truth and the Truth will set you free."
|
|
mcarter
podders Helping podders - pHp
Joined: 07 Apr 2016
Location: Greenbrier, TN
Online Status: Offline
Posts: 3419
|
Posted: 16 Feb 2019 at 4:45pm |
I have the FLEXCO steps, make sure you order right width and they also require some hole modification. Didn't take me long to remove single step, enlarge holes and install double step. Good mod.
|
Mike Carter
2015 178
" I had the right to remain silent, I just didn't have the ability."
|
|
offgrid
Senior Member
Joined: 23 Jul 2018
Online Status: Offline
Posts: 5290
|
Posted: 06 Mar 2019 at 6:31am |
Looks like Stomberg Carlson and Flexco are the same company. Just to be sure, did both of you get the SMFP2100 (24 inch double, 8 inch rise)?
|
1994 Chinook Concourse
1995 RV6A Experimental Aircraft
2015 Rpod 179 - sold
|
|
mcarter
podders Helping podders - pHp
Joined: 07 Apr 2016
Location: Greenbrier, TN
Online Status: Offline
Posts: 3419
|
Posted: 06 Mar 2019 at 8:34am |
I bought mine from etrailer, I measured my single step and got a compatible dual step. I did have to elongate two holes as I recall. There wasn't as many choices on etrailer.
|
Mike Carter
2015 178
" I had the right to remain silent, I just didn't have the ability."
|
|