Replace Batwing with Dish ANT |
Post Reply | Page <12 |
Author | |
StephenH
podders Helping podders - pHp Joined: 29 Nov 2015 Location: Wake Forest, NC Online Status: Offline Posts: 6289 |
Topic: Replace Batwing with Dish ANT Posted: 26 Oct 2019 at 4:45pm |
For comparison, this is mine: After using it for some time, I still would recommend it if it were to again be available. The Magnadyne is a good alternative and, apparently, also works well.
|
|
StephenH
Happy is the man that findeth wisdom,... ouR escaPOD mods Former RPod 179 Current Cherokee Grey Wolf 24 JS |
|
mcarter
podders Helping podders - pHp Joined: 07 Apr 2016 Location: Greenbrier, TN Online Status: Offline Posts: 3419 |
Posted: 26 Oct 2019 at 3:14pm |
Mike Carter
2015 178 " I had the right to remain silent, I just didn't have the ability." |
|
Craneman
Senior Member Joined: 12 May 2013 Location: Tokeland,wa Online Status: Offline Posts: 387 |
Posted: 25 Oct 2019 at 8:13pm |
Any pictures?.....
|
|
Jo and Gary, 2010-174,2011 F150
Jo and Gary 2010 174 2011 Ford 150 |
|
StephenH
podders Helping podders - pHp Joined: 29 Nov 2015 Location: Wake Forest, NC Online Status: Offline Posts: 6289 |
Posted: 25 Oct 2019 at 7:39pm |
Congratulations! I'm glad the Magnadyne was suitable for you. The hardest part for me was getting the wires though as the interior holes and roof holes were offset from one another. That may be because the roof was replaced on ours when it had to be repaired after the accident. Since the antenna I got used the same base, I was able to just swap out the head unit and keep the original metal base in place. I have three bases now. One is the original on the roof. One is the metal one like the original from the first replacement bat wing antenna that broke when it hooked a tree at a friend's house. The third is the plastic one that came with our flying saucer antenna.
|
|
StephenH
Happy is the man that findeth wisdom,... ouR escaPOD mods Former RPod 179 Current Cherokee Grey Wolf 24 JS |
|
mcarter
podders Helping podders - pHp Joined: 07 Apr 2016 Location: Greenbrier, TN Online Status: Offline Posts: 3419 |
Posted: 25 Oct 2019 at 4:14pm |
Replaced my batwing TV ANT on 2015 178 with a Magnadyne RVTB-B dish style antenna. The batwing performance was not impressive, it caught low hanging branches and always made cover install a pain. My other complaint was the distribution box and consistent issues with the amp switch. Removing the batwing was not difficult. I had to remove the radio assy., cut the 12V AMP line and disconnect the ANT coax. I cleaned off the lap seal and removed four screws that held base on. I thoroughly cleaned mounting surface, used the existing mounts hole to install Magnadyne base. The biggest issue I had was the antenna hole through the roof was not centered in the base. There's an approximately 3" hole in the Pod interior and a 1" hole in the roof. I used a 1" hole saw to make and additional hole more closely centered on the base and that allowed me to use the same mount holes. The Magnadyne ANT has the TV and the radio ANT in the dish, so there are two coaxes that have to come thru the roof. Once ANT was installed I moved inside. The kit comes with a new distribution panel and it operates much simpler than OEM. There is no 12V wiring going from box to antenna, so that wire can be removed, there no coax from box to radio (Radio ant is in dish on Magnadyne.) You do have to hardwire the 12V for AMP operation. Outside configuration is the same as old with ANT TV and Satellite ports on front. Installation was done in about 3 hours, cost about 70 bucks. Once installed I did a channel scan and picked up 10 channels more than batwing. That was here at my house in the clear. The dish is considerably smaller, making access to roof on that side mo' better. Also in my kit I got a radio ant extension cable so I did not have to buy any additional cables. Remember before you start you need sealant. Approximately 1 tube. I also used tape sealant on bottom side of base.
|
|
Mike Carter
2015 178 " I had the right to remain silent, I just didn't have the ability." |
|
Post Reply | Page <12 |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |