Hi all!
I got my first TT (190) last May before the heavy Covid hit. Since then have been on 5 trips including Yellowstone and various lakes around Washington. After years of tenting it's finally time to have some luxury during my fishing trips.
Searching the forums it appears to be a common issue with the bent axle and given that the carrying load is only 289 pounds, I may have exceeded it but I am not sure.
I have asked the dealership where I bought it to put in a warranty claim but an not holding my breath as my warranty is two months past the one year mark.
Both tires are 1" out of plumb...
A string line pulled tight across the axle shows only a 1/16" gap in the center...
My question is what is the best option of the solutions found here in the forum if there is no warranty help?
- Find someone to re-bend the existing and add a support like StephanH's support?
- I assume an alignment shop would do this and I can fab up the support myself.
- Buy a new one of the same and add the support?
- This way I can re-use my wheel, brakes and tires.
- Buy a new heavier Dexter 5000lbs.
- I assume I would also have to get new wheels and tires?
- Comes with peace of mind that I can carry fresh water in my tank for dry camping in the boonies without bending an axle.
Am I missing anything as far as issues? Is it best to stick with a torsion axle?
Keith