40 pound propane tank |
Post Reply | Page <123> |
Author | |
techntrek
Admin Group - pHp Joined: 29 Jul 2009 Location: MD Online Status: Offline Posts: 9059 |
Topic: 40 pound propane tank Posted: 05 Apr 2013 at 8:10pm |
A quick tip for finding out your actual LP level (if you don't have a float gauge) in under 30 seconds. Get a cup of hot water and slowly pour it down the side of the tank from the shoulder. Wait a few seconds and then run the back of your finger down the side. The steel will still be hot where there is no fluid, but will be cool below the fill level.
|
|
Doug ~ '10 171 (2009-2015) ~ 2008 Salem ~ Pod instruction manual
|
|
thadd
Groupie Joined: 06 Oct 2012 Location: Sacramento, CA Online Status: Offline Posts: 53 |
Posted: 05 Apr 2013 at 9:05pm |
I tried that several times but could never really get it to work. The float gauge approach is much easier too :).
|
|
techntrek
Admin Group - pHp Joined: 29 Jul 2009 Location: MD Online Status: Offline Posts: 9059 |
Posted: 06 Apr 2013 at 9:59pm |
Odd, I've never had a problem finding the exact level that way. The liquid propane acts as a heat sink.
|
|
Doug ~ '10 171 (2009-2015) ~ 2008 Salem ~ Pod instruction manual
|
|
Tars Tarkas
Senior Member Joined: 14 Jan 2013 Location: Near Nashville Online Status: Offline Posts: 1446 |
Posted: 07 Apr 2013 at 8:03am |
If the tank hasn't been in use everything will settle down to the ambient temperature, unless the ambient temperature has changed significantly very recently. What's really going to cause the parts of the tank with and without propane to be different temperatures is the evaporation of the liquid propane when the tank is in use. Depending on the humidity, even without pouring water on the tank you'll often see dew or even frost on the tank that indicates the LP level when the tank is in near-constant use. Check the tank in the morning when the heat has been on and the water trick should work great. TT |
|
techntrek
Admin Group - pHp Joined: 29 Jul 2009 Location: MD Online Status: Offline Posts: 9059 |
Posted: 07 Apr 2013 at 6:00pm |
There is liquid below and vapor above when a LP tank is at rest or while in use. Where there is vapor the steel of the tank retains the heat, where there is liquid it acts as a heat sink and pulls the steel back to ambient temperature which is why it feels cool. I've done this test in all types of conditions and the only time it doesn't work is when a tank has been sitting in the hot sun in the middle of summer. Covering it for a little while solves that problem.
|
|
Doug ~ '10 171 (2009-2015) ~ 2008 Salem ~ Pod instruction manual
|
|
Racer|X|
Senior Member Joined: 21 Mar 2012 Online Status: Offline Posts: 237 |
Posted: 07 Apr 2013 at 7:47pm |
IMHO...two 20’s and an auto-switch is the way to go vs. one 40.
Good luck!
|
|
Tars Tarkas
Senior Member Joined: 14 Jan 2013 Location: Near Nashville Online Status: Offline Posts: 1446 |
Posted: 07 Apr 2013 at 8:35pm |
Sorry, I didn't read your message carefully enough. I was thinking of the cooling caused by the evaporation of the liquid propane (or most any liquid quickly converting to gas). When the tank is in use you can do the water thing and the upper (gas) part of the bottle can cause the water to freeze, or you can easily feel that the upper portion of the bottle is cooler than the liquid (lower) part. Your method should work too, but it might be more subtle.
Anyway, I've never really worried about the propane level in portable or disposable bottles. I've never had an auto switchover set up, so when one bottle hits the bottom I just disconnect it and hook up another one. It's always seemed reasonable to me to carry a spare. TT |
|
SteveC
Newbie Joined: 05 Jul 2013 Location: Williamston, MI Online Status: Offline Posts: 20 |
Posted: 07 Jul 2013 at 9:43am |
The lite weight LP tanks caught my interest until I found the company is out of business. For those considering the lite LP tanks, lite cylinder has gone out of business after their LP tanks were deemed unsafe and a force recall placed on them. For current owners it is stated you should immediately discontinue using them. Here is a link to the recall notice. http://www.phmsa.dot.gov/portal/site/PHMSA/menuitem.ebdc7a8a7e39f2e55cf2031050248a0c/?vgnextoid=7c7384ae997be310VgnVCM100000d2c97898RCRD&vgnextchannel=d248724dd7d6c010VgnVCM10000080e8a8c0RCRD&vgnextfmt=print
|
|
2014 R Pod 178
|
|
Craneman
Senior Member Joined: 12 May 2013 Location: Tokeland,wa Online Status: Offline Posts: 387 |
Posted: 07 Jul 2013 at 10:57am |
Holy cow Tars where do you live to camp in 14 degree temps, I'm shure not in Florida Moe
|
|
Jo and Gary, 2010-174,2011 F150
Jo and Gary 2010 174 2011 Ford 150 |
|
Sleepless
Senior Member Joined: 07 Jun 2013 Location: Titusville, FL Online Status: Offline Posts: 556 |
Posted: 07 Jul 2013 at 1:12pm |
I had dual 30# tanks on my Dutchman Zoom which is not much larger than a pod. For me these were overkill in terms of capacity. One good thing about 30's is that a hard shell cover is available for them almost anywhere. (I don't know if similar covers are available for 40's). I still like the dual 20# setups because you can go almost anywhere and exchange them for full tanks. I don't feel like lugging 30 or 40 pound tanks around.
|
|
2014 R-Pod 178 (OUR POD)
2009 Chevrolet Avalanche |
|
Post Reply | Page <123> |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |