Air Conditioner |
Post Reply | Page <1 2345> |
Author | |
techntrek
Admin Group - pHp Joined: 29 Jul 2009 Location: MD Online Status: Offline Posts: 9059 |
Topic: Air Conditioner Posted: 28 Jul 2013 at 9:13pm |
Ditto when I cleaned mine - only the weight of my torso and that was laid mostly on the edge or flat across the roof when I was reaching to the middle. There is no way it will support someone walking on it, the floor has the metal frame but the roof is just some thin wood slats, insulation and fiberglass.
|
|
Doug ~ '10 171 (2009-2015) ~ 2008 Salem ~ Pod instruction manual
|
|
furpod
Moderator Group - pHp Joined: 25 Jul 2011 Location: Central KY Online Status: Offline Posts: 6128 |
Posted: 28 Jul 2013 at 1:58pm |
Almost exactly how I did it.. I did remove the old cap. I don't think the roof structure is to much different from the floor structure.. |
|
David and Danette
podders Helping podders - pHp Joined: 24 Nov 2009 Online Status: Offline Posts: 1215 |
Posted: 28 Jul 2013 at 1:53pm |
I have crawled on my roof several times to spread out the weight when washing and repairing AC. I weigh a 165 Lbs. I have had no problem, you do need be very careful near the front or back that you do not slide off. With the 171's you have some support from the wet bath under the roof. I have always climbed on the roof from the right side the side of the bath. I would not walk on the roof that would be to much weight in a small area. This is my own experience not recommending it for everyone you do need to use caution and your own judgement. I am lite weight someone much heavier I would recommend not to get on the roof. David
|
|
2018 Vista Cruiser 19BFD (2018-
2012 Vibe 6503 (2014-2019) 2009 r-pod 171 (2009-2014) Middle Tn 2014 Ram 1500 Quad cab |
|
Outbound
podders Helping podders - pHp Joined: 19 Nov 2009 Location: Oshawa, Ontario Online Status: Offline Posts: 767 |
Posted: 28 Jul 2013 at 11:12am |
When I replaced the start capacitor on my A/C, I just used a tall step ladder beside the r-pod and stood on the ladder/laid my weight on the roof's edge so that the vertical studs in the wall were bearing most my weight. It was a close enough reach to unscrew the shroud (had to move the ladder to the other side to get the other screws), zip-tie in the new capacitor and move the connectors. I left the old start capacitor in-place because there was plenty of room for both and I figured why not leave a spare?
Frankly, on that roof, I wouldn't want to put any more than 30 or 40 pounds on a point load the area of a shoe.
|
|
Craig :: 2009 RP171 towed by a 2017 F150
|
|
Sleepless
Senior Member Joined: 07 Jun 2013 Location: Titusville, FL Online Status: Offline Posts: 556 |
Posted: 28 Jul 2013 at 10:43am |
I have often wondered if the roof of the R-Pods will support the weight of a 200# person. I always walked on the roof of my past RVs for general cleaning and maintenance tasks, adding roof vent covers, etc. My only reason for asking is that I want to replace the A/C starting capacity and removing the shroud would me much simpler if I were on the roof. Yes, I am aware of the fall potential, but I would stay near the peak of the roof and use a non-slip mat to kneel on.
Bob |
|
2014 R-Pod 178 (OUR POD)
2009 Chevrolet Avalanche |
|
techntrek
Admin Group - pHp Joined: 29 Jul 2009 Location: MD Online Status: Offline Posts: 9059 |
Posted: 28 Jul 2013 at 12:11am |
Definitely not safe getting up there on a 6 foot ladder, but I wised up this year and used my back porch as a work platform. I posted photos a month or so ago somewhere around here.
|
|
Doug ~ '10 171 (2009-2015) ~ 2008 Salem ~ Pod instruction manual
|
|
kymooses
Senior Member Joined: 01 Aug 2010 Location: Louisville, Ky Online Status: Offline Posts: 1807 |
Posted: 27 Jul 2013 at 6:14pm |
The roof is very scary, just washing my AC last night I almost lost my ladder twice. DW had headphones on and couldn't hear my screaming.
|
|
furpod
Moderator Group - pHp Joined: 25 Jul 2011 Location: Central KY Online Status: Offline Posts: 6128 |
Posted: 26 Jul 2013 at 3:43pm |
BTW, if you need to, in the future, mess with it again.. they are stupid simple to replace. If you can put a window a/c in a house, you can do one of these. They all fit the same size hole. There is some caulking to be done, and of course the elctrical hook up,but I reckon a handy guy could do it in under an hour, first time. Took two on the 'stream, but I was scared of the "roof"..
|
|
Robwid
Groupie Joined: 31 Oct 2011 Location: Oregon Online Status: Offline Posts: 67 |
Posted: 26 Jul 2013 at 2:47pm |
Thanks for the advice gents. I'll let you know the outcome when it's complete.
|
|
Rob
2012 HRE 177 2010 Toyota Tacoma |
|
Outbound
podders Helping podders - pHp Joined: 19 Nov 2009 Location: Oshawa, Ontario Online Status: Offline Posts: 767 |
Posted: 24 Jul 2013 at 6:27pm |
I had my A/C "repaired" under warranty - it was freezing up. I assume it was low on refrigerant and they simply recharged it, although I never did ask what specifically was wrong. Its been fine for the past three years.
|
|
Craig :: 2009 RP171 towed by a 2017 F150
|
|
Post Reply | Page <1 2345> |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |