Mount rear camera on 195 ladder

Picking up my 195 in a few weeks and already purchased a Haloview MC7108 wireless rear camera and monitor.  What I'd like to do is (at the dealer before I leave) do an install without drilling by using a bracket similar to one used to mount a light bar to the rear ladder.  This is the bracket I'm looking at:

Our Sonoma came with a Furrion base plate mounted just below the 3 center running lights.  Since I didn't want to spring for an expensive camera, I got one on Amazon that worked with a cell phone.  I mounted it to the Furrion base plate and hooked the power supply to the running lights wires.  The base plate was just screwed onto the real fiberglass wall covering the cut out for the Furrion camera.  I reinforced the holes in the wall with those little metal screw clip nuts that I slid over the wall material.  It hasn't fallen off yet and works great.  

You may want to take a caliper and measure it.  If you don't have one, use an adjustable square and mark the other side of the tube, then measure it.  Likely it's in the neighborhood of 1", but that may depend on the particular supplier.  Our FR supplied ladder uses 1" tubing, but they may use a different supplier in the r-Pod factory.

Most of the cameras I saw when I looked for one to buy have a flat mounting base, for placement on a flat surface.  Since they are after market items, if you are able to find one that has a mounting kit for a ladder tube, it will probably be adjustable in the to accommodate tubing in the neighborhood of 1".  

Thank you all.  This really helps.