servo motors for RP-179 slider |
Post Reply |
Author | |
RoadToad
Groupie Joined: 18 Nov 2015 Location: Ninilchik Online Status: Offline Posts: 46 |
Topic: servo motors for RP-179 slider Posted: 23 Dec 2016 at 12:28pm |
When we recently left Alaska there was a lot of snow & ice on our slider which we had extended out(don't recommend this now that we have had trouble). We cleaned it all off with hot water & a broom- but apparently not good enough because when we slid the slider back in we heard some loud gear popping on the tracks and the forward servo(s) stayed 2"out from the sealing/molding strip when the slider stopped moving. We drove 2500 mi with it like that (fortunately too cold for rain!) til in Montana it finally got to the +40's*F and melted all the ice- then we ran the servos again and it closed just fine.
I am finding it hard to find info on these servos and how to re-aligne them if they get out of sink. Several old posts have links that are no longer accessible on servicing these motors. I'm not even sure if the RP-179 has two servos, or four. I found one factory vid where the tech said never stop & start them partially- always run them full in or out and wait while holding the switch on for a couple seconds after it reaches full in or full out. Any info on these procedures- and lubricating them would be appreciated.
|
|
2015 RP179
|
|
ronahue
Senior Member Joined: 02 Jun 2015 Location: Massachusetts Online Status: Offline Posts: 316 |
Posted: 23 Dec 2016 at 2:39pm |
This is a copy of the manual for trouble shooting. Their is also a video on you tube that describes how to realign the drives when they get out of sync. I can't find it right now if I do I will upload a link. The manual has a number for tech support and they should be able to help. Good Luck |
|
Ron & Sharon
2015 R-Pod 179 2022 Nissan Frontier No trees were harmed in the sending of this message but a billion electrons were really agitated |
|
ronahue
Senior Member Joined: 02 Jun 2015 Location: Massachusetts Online Status: Offline Posts: 316 |
Posted: 23 Dec 2016 at 2:43pm |
This is a link to the video on how to disconnect the drives for manual operations.
https://www.youtube.com/watch?v=YzqbvwCJpNU
|
|
Ron & Sharon
2015 R-Pod 179 2022 Nissan Frontier No trees were harmed in the sending of this message but a billion electrons were really agitated |
|
ronahue
Senior Member Joined: 02 Jun 2015 Location: Massachusetts Online Status: Offline Posts: 316 |
Posted: 23 Dec 2016 at 2:47pm |
Sorry that's the wrong video try this one.
https://www.youtube.com/watch?v=YzqbvwCJpNU
|
|
Ron & Sharon
2015 R-Pod 179 2022 Nissan Frontier No trees were harmed in the sending of this message but a billion electrons were really agitated |
|
Post Reply |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |