R-pod Owners Forum Homepage

This site is free to use.
Donations benefit a non-profit Girls Softball organization

Forum Home Forum Home > R-pod Discussion Forums > Podmods, Maintenance, Tips and Tricks
  New Posts New Posts RSS Feed: Bearing /seals numbers
  FAQ FAQ  Forum Search   Calendar   Register Register  Login Login

Topic ClosedBearing /seals numbers
 Post Reply Post Reply
Author
Message
  Share Topic Share Topic  Topic Search Topic Search  Topic Options Topic Options
Craneman View Drop Down
Senior Member
Senior Member
Avatar

Joined: 12 May 2013
Location: Tokeland,wa
Online Status: Offline
Posts: 387 		Direct Link To This Post Topic: Bearing /seals numbers
    Posted: 14 Sep 2015 at 5:05pm
can anyone give me the bearing and seal numbers for my prod 2010 174.  

          Moe
Jo and Gary, 2010-174,2011 F150

Jo and Gary
2010 174
2011 Ford 150



Back to Top
Pod People View Drop Down
Senior Member
Senior Member


Joined: 22 Sep 2011
Location: Chapel Hill,NC
Online Status: Offline
Posts: 1067 		Direct Link To This Post Posted: 14 Sep 2015 at 6:19pm
We have a 173 and I assume the axle/hubs are the same.  we used Car Quest part # 473336 for the dust seals.  They were 47.34 each.  We did not replace the bearings during the service.  Hope this helps.
Travel safe
Vann

Vann & Laura 2015 RPod 179
Back to Top
furpod View Drop Down
Moderator Group - pHp
Moderator Group - pHp
Avatar

Joined: 25 Jul 2011
Location: Central KY
Online Status: Offline
Posts: 6128 		Direct Link To This Post Posted: 14 Sep 2015 at 7:21pm
I certainly hope that's a typo, I picked up complete bearing kits at NAPA for less than the price of the seal you quoted.. 
Back to Top
Podster View Drop Down
Senior Member
Senior Member
Avatar

Joined: 16 Sep 2014
Location: San Antonio
Online Status: Offline
Posts: 1108 		Direct Link To This Post Posted: 15 Sep 2015 at 6:59am
I sure hope so as well. I paid less than $3.00 per seal direct from Lippert. 
Cliff & Raelynn
Ranger 4.0/178
(1/2 ton 5,800lb tow capacity)
Back to Top
Pod People View Drop Down
Senior Member
Senior Member


Joined: 22 Sep 2011
Location: Chapel Hill,NC
Online Status: Offline
Posts: 1067 		Direct Link To This Post Posted: 15 Sep 2015 at 8:36am
Yes, it was a mistake .  A BIG mistake!!.   the "4" should have been a  "$" I didn't hit the shift key  properly. .  I guess my fingers aren't as smart as I would like for them to be.

the actual cost was $7.34 for 2 seals.
Vann

Vann & Laura 2015 RPod 179
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down

Bulletin Board Software by Web Wiz Forums® version 9.64
Copyright ©2001-2009 Web Wiz